Methods/Steps
Step 1: Preliminary treatment
① Shaping: Use a standard file to trim the nails to the designed shape;
② Trimming dead skin: Use dead skin steel to push up the excess dead skin at the edge of the nail, and then use dead skin scissors to trim it;
③ Engrave and polish the nail surface and clean it: rub the rough surface with a sponge to polish the nail surface;
Step 2: Apply binder
The binding agent is a water-like body, and the amount should not be too much to avoid flowing or drying. The binding agent only needs to be smeared around the edge of the nail and the nail tip;
Step 3: Apply Base
The half-smear method is used to smear from bottom to top (first smear the lower half of the nail and then smear the entire surface upward, so that the color saturation is stronger and more uniform from top to bottom). The LED lamp must be used for 1 minute, and the UV lamp must be used for 3 minutes.
Step 4: Apply color gel
① The nail polish will be applied and taken. A little more nail polish will be piled around the edge to avoid block falling;
② Pay attention to the edging, LED light for 30 seconds, a UV light for 1 minute;
③ As above, the color saturation will be enhanced after the second coat;
Step 5: Apply the seal coat (Top)
The sealing layer must be measured, the edge will not be painted too thin, the color gel will be completely covered, the nail surface will be painted, and finally, the edge wrapping must be paid attention to. The LED lamp must last for 1 minute, and the UV lamp must last for 3 minutes.
